TEMPERATURE ADJUSTMENT
Use the button (
4
) to select the required temperature. To adjust the product temperature, proceed as follows:
• Press the button (4). With each press of the button, the set temperature will be changed cyclically between the
values “Eco”, “Normal”, “Intensive” and “Shopping”.
• Select “Intensive” for a colder storage temperature.
• In case of a partial load, it is advisable to select “Eco” to optimise energy consumption.
The green lights (
3
) indicate the selected setting as follows:
Eco:
less cold temperature (left light on).
Normal:
middle temperature (right light on).
Intensive:
very cold temperature (both lights on).
Shopping:
Quick Freeze (both lights on blinking). See the section “Freezing fresh
food”.
Note:
In case of a power failure, the settings (except for the “STOP FROST” function) remain stored. The time
required for the temperature inside the freezer to reach approximately the set value may vary depending on the
climatic conditions and the setting selected.
STOP FROST FUNCTION
The STOP FROST function significantly reduces the amount of frost that can form inside the product, collecting it in
the special easy to remove and clean “ICE BOX” (M) container. STOP FROST technology also allows easy
reopening of the lid at any time whenever deemed necessary, even repeatedly, always with the same effort.
The STOP FROST function is already activated when the product is switched on the first time (blue light on). It can be
deactivated/reactivated by keeping the button (4) pressed for at least 3 seconds.
Thanks to STOP FROST technology, the ambient humidity is largely conveyed inside the ICE BOX (M), where it turns
into ice.
Make sure to periodically remove the inside the ICE BOX (M)
following the cleaning procedure described below.
The frequency of cleaning operations required to ensure proper functioning of the system depends on the climatic
conditions in the place of installation (more frequent cleaning is advisable in places with high humidity). The lack of or
inadequate cleaning of the device can temporarily compromise its operation. Therefore, during normal use it is advisable
to check the level of ice accumulated in the Ice Box (M), also by means of the special inspection window (I).
Summary of Contents for ACO450
Page 10: ...5019 300 02891 ...
