c. Minimum dimensions of ventilation gaps
Induction hob over an oven
Induction hob over an drawer
d. Connection of the appliance to the supply mains
The connection between the plug and the appliance should use the power cord provided by the manufacturer,
which should not be longer than 1.5m. If the socket is not accessible after installation, an additional means of
disconnection must be provided for all poles
Note: If the power cord is damaged, it must be replaced by the manufacturer or its service department or similar
professional in order to avoid the dangerous.
The PCB is made in Germany, which complies with:
IEC 60335-2-6 : 2002 IEC 60335-2-9 : 2002
(in conjunction with IEC 60335-1 : 2001)
5
Air out
Air in
Air out
Air in
Special point to note on installation
Please do not disassemble the screws fixed on the sides on the top of the ventilation point of the induction cooker.
These two screws are fixed to ensure a gap of 10mm is kept between the induction cooker and the kitchen cabinet,
guaranteeing the induction cooker to have a good ventilation. The manufacturer is not responsible for any faults
and problems caused by unauthorised disassembling.
more than 15mm
more than 15mm
at least 100mm
at least 100mm
at least 40mm
at least 40mm
Built-in oven
Wall
Wall
less than 35 mm
less than 35 mm
PCB board
PCB board
Table Top
Table Top
Ceramic glass
Ceramic glass
10mm
10mm
