3. MAINTENANCE
TROUBLESHOOTING GUIDE
Clean the hob after each use in order to avoid damaging the surface and to prevent the formation of baked-on
deposits which are difficult to remove. Before cleaning, make sure the cooking zones are switched off and that the
residual heat indicator is not displayed.
• Never clean the hob with a steam cleaner!
• Periodically check for dust under the appliance, near the cooling air inlet or the outlet openings.
This could hinder the ventilation and cooling of the electronic module and decrease the effective
ness of the hob.
To clean the hob, proceed as follows:
1. Use a soft clean cloth, absorbent kitchen wipes or a proprietary cleaner for glass ceramic hobs. Do not use
abrasive sponges and/or metal scouring pads.
2. Food spills should be cleaned off before they bake onto the glass ceramic surface. Sugar and foods with a high
sugar content damage the glass ceramic surface and must be immediately removed using a scraper for glass.
Glass scrapers must be handled with care.
3. Remove any stubborn food residues with a scraper or proprietary detergents.
4. Salt, sugar and sand can scratch the glass ceramic hob: clean up any such spills on the hob immediately.
Before contacting After-sales Service:
• Read and follow the instructions given in the section “Operating instructions”.
• Connect the hob to the electricity supply and check that the supply has not been shut off.
• Clean the hob and dry it thoroughly.
• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.
4. BASIC INSTALLATION
The voltage, rated load and fusing are listed on the data plate. Please make sure that these match your household
supply mains.
a. Dimensions of space to be provided for the appliance
b. Dimensions and positions of the means for
supporting and fixing the appliance within this
space
Warning! If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately
from the power supply.
4
E2
Cooking is being interrupted
•
Cook again after cooling
down
•
Clear the air vent
E3
Control panel switches off
beacuse heating is
interrupted
•
Water or utensils on control panel
•
Incorrect cook pot is used
•
Pot is moved during cooking
•
Pot is removed during cooking
•
Use a correct cook pot
•
Place cook pot at center of
cooking area
•
Empty pot
•
High temperatures
•
Air vent is blocked
ERROR CODE
DESCRIPTION
POSSIBLE CAUSES
REMEDY
700mm
643mm
58.5mm
400mm
343mm
Table Top
at least
50mm
at least
50mm
at least 60mm
Air out
Ventilation gap
(650W x 15H mm)
at least 60mm
Cut out dimensions
(643W x 343D mm)
