13
Introduction for buttons on remote controller
Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel
[
mode
Sleep 1 is Sleep mode 1, in Cool modes; sleep status after run for one hour, the
main unit setting temperature will increase 1
ʝ
. After
two hours, setting
temperature increased 2
ʝ
, then the unit will run at this setting temperature; In
Heat mode: sleep status after run for one hour, the setting temperature will
decrease 1
ʝ
.
A
fter
two hours, setting temperature will decrease 2
ʝ
, then
the unit will run at this setting temperature.
Sleep 2 is sleep mode 2, that is air conditioner will run according to the
presetting a group of sleep temperature curve.
[$[!%*
(1)Under Sleep 3 mode, press “Turbo” button for a long time, remote controller
enters into user individuation sleep setting status, at this time, the time of remote
controller will display “1hour”, the setting temperature
will display the
!$\
Default
temperature will be shown for the initial use
);
\]
Press
to
!#!
(3)
At this time, 1hour will be automatically increased at the timer pos
i
tion on the
! \ ]
! !
curve and blink;
(4)
Repeat the above step (2)~(3) operation, until 8 hours temperature setting
finished, sleep,curve setting finished, at this time, the remote controller will
resume t
o
original timer display; temperature display will resume to original
setting temperature.
[$[!%*
+j
The
user could accord to sleep curve setting method to inquire the presetting
sleep
curve, enter into user individuation sleep setting status, but do not change
!#!j*$
presetting or enquiry procedure, if
no button is pressed within 10s
, the sleep
curve setting status will be automatically quit and resume to the original
*+'_'QQ>
#
