background image

6

SAFETY ADVICES AND GENERAL 
RECOMMENDATIONS

1. Packing 

The packing box may be fully recycled as 
confirmed by the recycling symbol

.

2. Energy saving tips

Always dry a full load: depending on the type of 
laundry and the programme/drying time.

By preference use the maximum spin speed allowed 
by your washing machine, since draining the water 
mechanically requires less energy. You will save time 
and energy when running your drying cycle.

Do not overdry the laundry.

Clean the lint filter after every drying cycle.

Place your dryer in a room with a temperature 
between 15° C and 20° C. In case of higher 
temperature ventilate the room.

Always select the correct programme/drying time for 
the load in order to obtain the desired drying results.

Select the gentle option only with small loads.

When drying cotton, for example. dry iron dry and 
cupboard dry loads together. Start with the iron dry 
programme/drying time setting, remove the laundry 
to be ironed at the end of that cycle and dry the 
remainder of the load on the cupboard dry setting.

3. Disposing of packaging and old Dryer:

The dryer is built from reusable materials. The 
dryer must be disposed of in compliance with local 
waste disposal regulations. 

Before scrapping, cut off the power cable so that 
the dryer cannot be connected to the mains.

4. Child safety:

Children must not be allowed to play with the dryer.

5. General recommendations:

Always set the programme/time selector knob to 
the “0” position after use.This prevents the dryer 
from being switched on accidentally.

Before cleaning or carrying out maintenance, switch 
off the dryer and disconnect it from the mains supply.

To clean the outside of the dryer, use a neutral 
detergent and a damp cloth.

Do not use abrasive detergents.

Do not use inflammable cleansing agents. 

Do not use the tumble dryer if chemicals have been 
used for cleaning.

Garments treated or contaminated with flammable 
cleaning sprays or liquids such as petrol, cooking oil 
or aerosol sprays must not be put in this dryer. 

Lighters must not be left in pockets. 

Never use and store flammable materials nearby 
the dryer.

Wipe away lint from the door seal and the door 
using a damp cloth.

If the lint filter mesh is clogged, clean it with water 
and a soft brush.

Since lint can go through the filter it is necessary to 
clean, from time to time, the complete filter area 
(including below the filter) with a brush, a damp 
cloth or with a vacuum cleaner.

If necessary, the power cable may be replaced with 
an identical one obtained from our After-Sales 
Service. The power cable must only be replaced by 
a qualified technician.

 Attention rear panel can be hot.

EC Declaration of Conformity

This dryer has been designed, constructed and 
distributed in compliance with the safety 
requirements of EC Directives:
• 73/23/EEC Low Voltage Directive
• 89/336/EEC EMC Directive
• 93/68/EEC CE Marking Directive.

This appliance is marked according to the European 
directive 2002/96/EC on Waste Electrical and 
Electronic Equipment (WEEE).

By ensuring this product is disposed of correctly, you will 
help prevent potential negative consequences for the 
environment and human health, which could otherwise be 
caused by inappropriate waste handling of this product. 

The symbol 

 on the product, or on the 

documents accompanying the product, indicates that 
this appliance may not be treated as household waste. 
Instead it shall be handed over to the applicable 
collection point for the recycling of electrical and 
electronic equipment. 
Disposal must be carried out in accordance with local 
environmental regulations for waste disposal.
For more detailed information about treatment, 
recovery and recycling of this product, please contact 
your local city office, your household waste disposal 
service or the shop where you purchased the product.

The dryer must be used in the household for the 
described uses. 

Summary of Contents for 7913










Reviews: