■
New installation?
Flush and fill the water system.
■
Water filter installed on the refrigerator?
The filter may be
clogged or incorrectly installed.
■
Is a reverse osmosis water filtration system connected to
your cold water supply?
See “Water Supply Requirements”
in either the Installation Instructions or the Use & Care Guide.
Water is leaking from the dispenser
NOTE:
One or two drops of water after dispensing is normal.
■
Glass not being held under the dispenser long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
■
New installation?
Flush the water system. See “Prepare the
Water System” or “Water and Ice Dispensers.”
■
Recently changed water filter?
Flush the water system. See
“Prepare the Water System” or “Water and Ice Dispensers.”
The dispenser water is not cool enough
NOTE:
Water from the dispenser is chilled to only 50°F (10°C).
■
New installation?
Allow 24 hours after installation for the
water supply to cool completely.
■
Recently dispensed large amount of water?
Allow
24 hours for water supply to cool completely.
■
Water not been recently dispensed?
The first glass of water
may not be cool. Discard the first glass of water.
■
Refrigerator connected to a cold water pipe?
Make sure
the refrigerator is connected to a cold water pipe. See “Water
Supply Requirements.”
ASSISTANCE OR SERVICE
Before calling for assistance or service, please check
“Troubleshooting.” It may save you the cost of a service call. If
you still need help, follow the instructions below.
Contact the dealer from whom you purchased the refrigerator or
a Whirlpool designated service company.
If you need replacement parts
Look for quality replacement parts whenever you need a
replacement part for your Whirlpool appliance.
To locate factory specified replacement parts in your area,
contact the dealer from whom you purchased your refrigerator or
a Whirlpool designated service center.
Warranty
Contact the dealer from whom you purchased the refrigerator for
warranty information.
Keep this book and your sales slip together for future
reference. You must provide proof of purchase or installation
date for in-warranty service.
Write down the following information about your appliance to
help you obtain assistance or service if you ever need it. You will
need to know your complete model number and serial number.
You can find this information on the model and serial number
label, located on the inside wall of the refrigerator compartment.
Dealer name ____________________________________________________
Serial number ___________________________________________________
Address_________________________________________________________
Phone number___________________________________________________
Model number ___________________________________________________
Purchase date ___________________________________________________
Accessories
To order accessories, contact your authorized Whirlpool dealer
and ask for the appropriate part number listed below.
Stainless Steel Cleaner & Polish:
Part #4396095
Cabinet Side Trim Kits:
Part #2208187S - Stainless Steel Trim Kit
Part #2208187W - White Trim Kit
Part #2208187B - Black Trim Kit
Part #2208187T - Biscuit Trim Kit
Decorative Door Panel Kits:
Part #4378123 - White Cabinet Color
Part #4378124 - Black Cabinet Color
Part #4378125 - Biscuit Cabinet Color
Replacement Filters:
Standard Base Grille Water Filter Cartridge:
Part #4392857 (NL300 and L500)
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
W10129871A
© 2007 Whirlpool Corporation.
All rights reserved.
® Registered Trademark/TM Trademark of Whirlpool, U.S.A.
9
/07
Printed in U.S.A.
Summary of Contents for 5ED2FHKXRL05
Page 1: ......
Page 17: ...17 Notes ...
Page 33: ...Notas 33 ...
Page 64: ...W10129871A 2007 Whirlpool Corporation 저작권 보유 Whirlpool U S A 의 등록 상표 TM 9 월 7 일 미국에서 인쇄 ...