Whirlpool 4322658A, Manual

Page: 21 / 48

4-7
3. To reinstall the motor:
a) Remove the two screws from the hex
drive shaft coupling holder and remove
the coupling assembly.
b) Install the hex drive shaft in the motor
as far as it will go.
c) Slide the new motor assembly back into
place in the freezer door and mount it
with the four screws you removed ear-
lier. Make sure that the top of the hex
drive shaft, spring, and pin are through
the hole in the ice container plate.
NOTE: On 2002, and later models, the
pin is not used.
d) Plug the harness connector into the mo-
tor. NOTE: The connector is designed
to fit only one way on the motor termi-
nals.
e) Position the motor housing cover so that
the raised center faces the motor, and
mount it in place with the two screws
you removed earlier.
f) Make sure that the spring and pin are
in the center hole of the hex drive shaft,
and that the bearing and seal are prop-
erly positioned on the coupling, as
shown.
Push Down
On Coupling
g) Position the coupling assembly over the
spring-loaded pin, then push down on
the coupling and align it with the top of
the hex drive shaft. Secure the coupling
assembly with the two screws you re-
moved earlier.
Hex Drive
Shaft
Coupling
Seal
Bushing
Coupling
Holder
Screw
Screw
Hex Drive Shaft Coupling
Spring
Hex
Drive
Shaft
Pin
Continued on the next page.