Whirlpool 4322658A, Manual

Page: 16 / 48

4-2
REMOVING THE ICE MAKER & THE WATER FILL TUBE
Ice Maker
Door Pin Ice Maker
Door Pin
e) From the rear of the ice maker, lift the
top of the wire shield slightly and pull it
back to release it from the ice maker.
f) Press up on the two retaining clips (one
on each side) at the bottom of the ice
maker tracks with a fingernail of each
hand, pull the ice maker forward, and
remove it.
1. Disconnect the unit from the electrical
supply.
2. To remove the ice maker:
a) Open the freezer door.
b) Close the spring-loaded emitter door
and open the ice maker door.
g) If you are completely removing the
ice maker,
unplug the wiring harness
connector from the ice maker.
c) Push the ice maker door to the left so
that the right pin disengages from the
pivot arm, then lift the pin out of the
pivot, and remove the left pin.
Emitter Door Open
Emitter Door Closed
d) Remove the wire shield screw from the
bottom of the ice maker.
Track
Wire
Shield
Harness
Connector
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
WARNING
Open Ice Maker Door
Push
Lift
Wire Shield Screw
Retaining Clip
(1 on each track)