7
Drain hose
shipped inside tub
Numbers
correspond
to steps.
3369671-C
8. Latch the dishwasher door. Push dishwasher into place,
sliding drain hose through hole cut in cabinet opening.
(continued)
Do Not pinch power supply cord or kink power
supply cable between dishwasher and cabinet.
Check that front leveling legs are firmly against the floor.
Align dishwasher door with cabinet doors so that spacing
is the same on both sides.
9. Connect drain hose to an air gap or waste tee using one
of the recommended or alternate methods.
If connecting drain hose to an air gap or waste tee, cut
end of drain hose as shown.
Secure drain hose with screw-type hose clamp provided.
Do Not cut drain hose when connecting to a
7
⁄
8
" disposer
connector. Knock out plug from disposer inlet. Secure
drain hose with hose clamp provided.
DO NOT cut ribbed section to shorten drain hose.
7. Put spring-type drain hose clamp over connector. Push
drain hose onto connector. Use pliers to open and slide
clamp over drain hose and connector. Check for good fit.
If screw-type clamp is supplied instead of spring-type
clamp, use a
5
⁄
16
" nutdriver to tighten securely.
Cut hose connector to fit if needed
For additional height:
1. Add shims under the wheels.
2. Turn front levelers (each turn adds
1
⁄
16
" in height).
Loosen and then turn front levels the number of times
indicated in the chart.
You may have this type drain connector . . .
. . . or this type.
6. The dishwasher is shipped to be installed in a cabinet
opening with a 34" (86 cm) height. Measure height of
cabinet opening from the front edge of the underside
of cabinet opening to floor. Check chart for that height
opening. Put the wheels in the required position. The
dishwasher should be installed as level as possible
from front to back.
Wheel position
Minimum
Number Of Turns
Cutout
Wheel Position
To Preadjust
Height
(See Illustration)
Levelers
33
7
⁄
8
" (86 cm)
1
0
34
1
⁄
16
" (86.5 cm)
2
3
34
1
⁄
4
" (87 cm)
3
6
34
7
⁄
16
" (87.5 cm)
4
9
