3-5
Cooking Products Service Manual
Original April, 1996
4321972
© 1996 Whirlpool Corporation
Page 3-5
4.
Remove the five control knobs from the
control shafts.
5.
Remove the indicated torx screw and the
metal insert from each of the the controls
and remove the control panel.
6.
Remove the four hex-head screws from
the control cover.
OFF
HI
10
9
8
7
6
4
3
2
LO
CONTROL
KNOB
TORX
SCREW
METAL
INSERT
CONTROL
PANEL
HEX SCREWS (4)
CONTROL
COVER
7.
Remove the 10-screws shown in the illus-
tration and lift the top off the burner box.
REASSEMBLY NOTE: When you install the
control cover, first secure the left mounting
hole of each element control to the cover with
a
short
torx screw. Make sure that you align
the right mounting holes after you tighten the
screws so that you can install the longer torx
screws later. Also use two
short
torx screws
to secure the fan control to the control cover.
Position the fan control with the flatted shaft
facing the front.
2 HEX-HEAD
SCREWS
BURNER BOX
COOKTOP
4 SCREWS
AT THIS LOCATION
4 SCREWS
AT THIS LOCATION
