Page 2
1/4-20 x 3/4"
SS
SCREW
SPLIT LOCK WASHER 1/4"
1/4-20 SQUARE
NUT NICKEL
PLATED BRASS
1/4-20 x 3/4"
CARRIAGE SCREW
HOOD
HINGE
MOUNTING
B R A C K ET
BAIL BRACKET
1/4" FLAT WASHER
1/4" FLAT
WASHER
1/4" FLAT
WASHER
1/4-20
ELASTIC
STOP NUT
1/4-20 X 3/4
HEX HEAD BOLT
Mounting hole
for Pioneer Micro™
Mounting hole
for Pioneer Nano™ NP Series
and Continuum™ 3 or 6
1/4" FLAT WASHER
NOTE: Driver Side
mounting is shown
here.
1/4-20 ELASTIC STOP NUT
This bracket will mount to the hood hinge using existing mounting holes and supplied mounting hardware. There is a driver
and passenger side bracket indicated in the serial number by a “D” (driver) or “P” (passenger). This bracket will fit either the
Pioneer Nano™ NP Series, The Pioneer Micro™ Series or the Continuum™ 3 or 6.
Installation:
1.
Secure the driver and passenger side mounting
brackets to the hood hinges using the supplied
mounting hardware as shown. Tighten all
mounting hardware.
NOTE: The Pioneer Nano™ NP Series
is shown here for example.
2.
Mount your lights to the mounting
brackets and tighten all mounting
hardware.
NOTE: There are two mounting holes
in the bracket to secure the light.
Make sure you use the correct
mounting hole for your light (see
illustration).
3.
Extend the power and ground wires for
the lights to your power
source. Follow the
instructions that come
with your light.
CAUTION! DO NOT LOOK DIRECTLY AT THESE LED’S
WHILE THEY ARE ON. MOMENTARY BLINDNESS AND/OR
EYE DAMAGE COULD RESULT!
IMPORTANT WARNING!
