Page 5
Port for
Future Expansion
Microphone
Port
USB Port
PIN 1 - Power (RED)
PIN 10 - Ground (BLK)
PIN 2 - Back Light (YEL)
PIN 11 - Not Used
PIN 3 - Not Used
PIN 12 - AUX. Input #1 (WHT/BRN)
PIN 4 - Not Used
PIN 13 - AUX. Input #2 (WHT/RED)
PIN 5 - Not Used
PIN 14 - Horn Transfer Input (WHT/ORN)
PIN 6 -
ORN
Horn Transfer Relay (
)
PIN 15 - Not Used
PIN 7 - AUX. Out #2 (RED/WHT)
PIN 16 - Not Used
PIN 8 - AUX. Out #1 (BRN)
PIN 17 - Not Used
PIN 9 - Radio Speaker (BLU)
PIN 18 - Radio Speaker (BLU)
1.
10.
2.
11.
3.
12.
4.
13.
5.
14.
6.
15.
7.
16.
8.
17.
9.
18.
PIN 1 - Serial Communication A (BLU)
PIN 2 - Serial Communication B (GRY)
PIN 3 - Audio Out (WHT)
PIN 4 - Ground (BLK)
PIN 5 - Shield (None)
19.
20.
21.
22.
23.
1. Network Monitor
2. Control Head Monitor
3. Aux
#1
4. Aux
#2
5. Horn Relay
6. Not Used / Future Expansion
7
Output
Monitor
Output
Monitor
Monitor
. Not Used / Future Expansion
8. Not Used / Future Expansion
(Rear View)
Diagnostic Monitors
ON=OK Flashing=Problem
ON=Connected OFF=Disconnected
ON=ON OFF=OFF
ON=ON OFF=OFF
ON=Active OFF=Inactive
Control Head Connector Cable
Control Module
Input/Output Identification
1
10
2
11
3
12
5
14
6
15
7
16
8
17
9
18
4
13
1
2
3
4
5
1
2
3
4
5
6
7
8
Wiring
WARNING!
All customer supplied wires that connect to the
positive terminal of the battery must be sized to supply at least 125%
of the maximum operating current and fused “at the battery” to carry
that load (see wire chart on page 7).
NOTE: Item numbers reference the illustration found below.
Control Head
1.
Route the control head cable (provided) from the Control Module to
the designated mounting location. Plug this cable securely into the
rear of the control head. Be sure to use the built-in cable strain relief
when routing the cable away from the control head. This will prevent
the cable from being accidentally disconnected.
Radio Rebroadcast (Items 9 & 18)
Two (2) BLU wires are used to connect your two-way radio’s external
speaker for radio re-broadcast. This is an optional connection and will not
effect the other operations.
Note:
Radio re-broadcast will NOT work with amplified remote speakers!
If your remote speaker is amplified (i.e.: contains a power amp circuit in
the speaker assembly), do not enable the radio re-broadcast feature.
1.
Locate the two wires that connect the external speaker to the two-
way radio, cut one of them and splice one of the BLU wires into this
circuit.
2.
Cut the remaining speaker wire and splice the remaining BLU wire
into this circuit.
Cntrl Head Cable
Strain Releif
Backlighting (Item 2)
1.
Route the YEL wire (included) from the control module to the
vehicle’s marker light circuit.
2.
Splice this wire into this circuit to enable the control head backlighting
to be active whenever the vehicle’s marker light is active.
Aux. Inputs (Items 12 & 13)
Typical Input connections: K-9 Temperature Sensor, Burglar Alarm, etc..
Aux. Input #1
WHT/BRN (Item 12)
Ground Activated
Aux. Input #2
WHT/RED (Item 13)
Ground Activated
Aux. Outputs (Items 7 & 8)
Typical Output connections: Gun Lock, Trunk Release, etc..
Aux. Output #1
BRN (Item 8)
Provides Switch Relay
Aux. Output #2
RED/WHT (Item 7)
Provides Switch Relay
Hands-Free Siren (Items 6 & 14) (Optional)
1.
Using a customer supplied relay capable of handling the current of
your vehicle horn, connect as shown below.
System Power (Items 1 & 10)
1.
Using appropriately sized wire (see wire gauge chart), extend the
RED & BLK wires from the Multi-purpose Connector to the vehicle
battery.
2.
Route the BLK wire from the control module to the vehicle’s chassis
ground typically adjacent to the battery.
3.
Route the RED wire from the control module to the vehicle battery.
After all wiring connections have been made, connect the RED wire
to the POSITIVE (+) battery terminal. Fuse this wire @ 5 Amps.
Hands-Free Transfer
Relay
Horn Ring
Transfer Relay
(Customer Supplied)
Bosch™
Style
Generic
Style
To Vehicle
Car Horn
From Vehicle
Horn Relay
To Horn Ring
Transfer Relay
(Item 6)
To Horn Ring
Transfer Relay
(Item 6)
To
Horn Transfer Input
(Item 14)
To Horn
Transfer
Input
(Item 14)
30
87A
85
86
87
To Vehicle
Car Horn
NO
NC
From Vehicle
Horn Relay