Page 4
POWER SUPPLY ASSEMBLY
MOUNTING HOLES
TRANSISTOR
MOUNTING
STUDS
TRANSISTOR
MOUNTING BOSS
TRANSISTOR
SPRING CLIP
CHO-THERM
INSULATOR
ASSEMBLY INSTRUCTIONS OF STROBE LIGHT
POWER SUPPLY ASSEMBLY TO CAST ALUMINUM
BASE, TO PREVENT ELECTRICAL SHORT CIRCUIT
BETWEEN THESE TWO PARTS
WARNING:
FIGURE 1.
FIGURE 2.
FIGURE 3.
The strobe light power supply is a high voltage device.
Do not touch or remove strobe tube assembly while unit is in operation.
Wait at least 10 minutes after turning off power before starting work or
any trouble shooting on the unit. On this page is described the assembly
procedure of the strobe light power supply to the cast aluminum base.
It is extremely important that the assembly steps, as described below,
be followed exactly, to insure the proper insulation of the strobe light
power supply from the cast aluminum base.
Lower the power supply assembly onto the cast aluminum
base, with the three mounting holes lined up with the holes located on
the three mounting studs of the cast aluminum base. During this ass-
embly operation, the transistor on the power supply assembly has to be
positioned on the outside of the transistor mounting boss. Secure the
strobe light power supply assembly to the mounting studs with enclosed
self tapping screws.
Slightly bend the transistor on the power supply away from
the transistor mounting boss. Slip the Cho-Therm insulator behind the
transistor with the hole directed towards the top (see figure 4 “A”).
Position the top of the Cho-Therm insulator against the circuit board
of the power supply assembly, making sure that some of it shows below
the transistor (See figure 4 “B”). It is important that the transistor on the
power supply assembly does not contact the transistor mounting boss at
any place, as to prevent a damaging electrical short circuit between the
strobe light power supply and the cast aluminum base.
Use the transistor spring clip to secure firmly the Cho-Therm
insulator and the power supply transistor to the mounting boss of the
cast aluminum base. Wrap one end of the clip around one side of the
mounting boss, then press the other end in position using needle nose
pliers. (See figure 5 and note in figure 4 “B”).
TOP VIEW OF TRANSISTOR
MOUNTING BOSS
SPRING CLIP AROUND ONE END OF
TRANSISTOR MOUNTING BOSS
PUSH OTHER END OF TRANSISTOR SPRING CLIP
AROUND OTHER END OF TRANSISTOR
MOUNTING BOSS
CHO-THERM INSULATOR AND TRANSISTOR TO BE SECURED
BETWEEN TRANSISTOR SPRING CLIP AND TRANSISTOR
MOUNTING BOSS (SEE NOTE IN FIGURE 4 “B”)
FIGURE 5.
FIGURE 1.
FIGURE 2.
FIGURE 3.
TRANSISTOR
SPRING CLIP
MUST PRESS
AGAINST THIS
PART OF THE
TRANSISTOR
“B”
“A”
FIGURE 4.
