WWW
.W
HEELSFORFEET
.
COM
425-256-2882
5/2/2016
disengaged. The scooter should always be returned to drive mode to
lock the brakes before leaving the scooter occupant
unattended or returning control of the scooter back to the user.
The lever is located on the right back side of the scooter. Push the
freewheel mode level towards the
•
Rear direction to engage motor to move scooter.
•
Forward direction to disengage motor, and to push by hand
.
Figure 2-
Freewheel
A
SSEMBLY
1.
Place the freewheel mode lever in the drive position.
2.
Set the rear section in the up position and make sure the hook for the
front section is connected to the axle of the rear section. (See Fig. 3)
3.
Put down the front and rear sections until the scooter is level. (See
Fig. 5)
4.
Set down the battery pack on the scooter, and make sure it is in the
correct position.
5.
Set down the seat on the seat post until the swivel lock engages and
you hear a click.
6.
The dis-assembled pieces are pictorially depicted in Figure 3 below.
Figure 3
Caution!
•
Make sure you connect all pieces together properly.
•
Turn off all power to your scooter and remove key from key switch
to prevent accident before disassembly.
•
Pay careful attention while assembling to avoid finger injuries
Figure 4
Figure 5
C
HARGING
When the key is switched “ON”, the battery gauge will display
the battery power capacity by indicating red, yellow and green
lights respectively. Green lights indicate a full charge. Red lights
indicates low power.
