Audio Output Connections:
-Select the ‘
LINE
’ position of the ‘
LEVEL’
switch (
10
) when the output of the receiver is
connected to the line level input of a mixer or amplifier. Select the ‘
MIC
’ position of the ‘
LEVEL
’
switch (
10
) when the output of the receiver is connected to a microphone level input of a mixer.
Overload conditions may occur if the ‘
LEVEL
’ switch is set to the wrong position.
-
The ‘
BALANCED OUTPUT
’
(11)
should be used when the receiver is going to be connected to
either a microphone or line level, balanced input of a mixer.
Excessive cable length for a balanced connection is generally not a problem.
-
The ‘
UNBALANCED OUTPUT’
(
12
) should be used when the receiver is going to be connected
to the ¼” input jack of a mixer or an amplifier (usually line level) that uses a ¼” phone plug. Use
the appropriate setting on the ‘
LEVEL
’ switch (
10
) on the rear panel of the USX-800. Cable length
for this type of connection should be limited to less than 15 feet (5 meters).
Fig.8 Fig.9
Fig.10
6
Summary of Contents for USX 800
Page 1: ...Wireless Microphone ...
