Wetelux 93 31 42, Original Instructions Manual

Page: 14 / 22

10
Operation
with a danger sign. In addition, switch off the associated earth-leakage
circuit breaker.

Check that the mains connection is current free with a suitable tester.

The earth protection cable must be connected when installing the LED
light.

Do not install the LED light, if the LED light is replacing an existing light
and there is no protective earth cable available. First, draw a new
mains cable.

Where the protective earth is not connected, a fault with the mains
voltage might result in the metal housing of the LED light becoming live.
There is a risk of a life-threatening electric shock!

When drilling in walls and ceilings, pay attention to cables, gas and
water pipes.
Mounting/Installation
1.
Connect the three wires of the power cable with the wires of the LED
light.
N = Blue
L = Brown/Black
= PE (Green/Yellow)
WARNING! Risk of electric shock! The light may only be operated
when connected to ground.
2.
Install the wall mount with two or three suitable screws securely to an
appropriate place. Make sure the light is securely mounted.
3.
Loosen the screws, tilt the light to the desired angle and tighten the
hinge adjusting screws of the wall mount to secure its position.
Switching ON
The LED light is switched on by plugging into mains or by supplying pow-
er.
Cleaning

Clean the housing of the light only with a dry or lightly moistened cloth.
Do not use aggressive chemicals or abrasives for cleaning.