11
Operation
Mounting/Installation
Remove the four screws from rear side of the LED spotlight and
remove the rear part of the housing.
Turn off the nut from the cable gland (5) and lead the power ca-
ble through the cable gland at the side of the housing. Then turn
on the nut again.
Connect the three wires of the power cable, as pictured below,
with the lustre terminal which is located inside the housing of the
LED spotlight. Then secure the power cable with the strain relief.
Reassemble the housing in reverse order and secure it with the
four screws.
The LED spotlight can be used indoors as well as outdoors. The
LED spotlight is splash proof (IP44).
Install the wall mount (6) with two or three suitable screws se-
curely to an appropriate place.
Tilt the spotlight to the desired angle and tighten the screws at
the hinge of the wall mount to secure its position.
Note:
Before installing the spotlight permanently to a wall, check
the proper functionality and the field of view of the motion sensor
(1). Select a suitable place of installation in order to have the
spotlight activated in time when passing the motion sensor.
L N
L = Brown
N = Blue
= Green / Yellow
