Wetelux 82 74 07, Instruction Manual

Page: 17 / 26

13
Using
Using
You can operate the lamp and control the light two ways: via the
remote control and via the On/Off key.
Operating via On/Off key
1. Press the On/Off key (2). The LEDs shine with the highest
brightness level.
2. Press and hold the On/Off key. The light of the LEDs slowly gets
darker and then brighter again in a cycle sequence. Release the
key when the desired brightness level has been reached.
3. Press the On/Off key again to switch off the lamp.
Operating via the Remote Control
Remove the remote control (7) from the mounting bracket (5) and
point at the lamp when using it. If the mounting bracket has been
installed in the vicinity of the lamp, you may use the remote control
while it is sitting in its mounting bracket.
1. Press the On/Off key (6) of the remote control. The LEDs shine
with the highest brightness level.
2. Press and hold the On/Off key. The light of the LEDs slowly gets
darker and then brighter again in a cycle sequence. Release the
key when the desired brightness level has been reached.
3. Press the On/Off key again to switch off the lamp.
Replacing the Batteries of the Remote Control
If the lamp does not react on the remote control any more, the
battery of the remote control should be replaced as follows.
1. Remove the screw of the battery compartment cover of the
remote control.
2. Replace the existing battery with a new one of the same type and
dimensions (CR2032). Pay attention to the proper polarity of the
battery. The plus pole faces out of the battery compartment.