ADJUSTING THE X-OVER, BASS BOOST AND PHASE
3 - The Variable Crossover Network
allows adjustment of the frequency
range that the amplifier sends to the subwoofer. This should be adjusted to
fall slightly above the lowest frequency that the full range speaker/s in the
system can reproduce.
4 - The Variable Bass Boost
allows the selection of the amount of bass
boost – centered at 45Hz - that is desired in the system. There is no specified
setting for this. It is suggested to be set by the listener’s preference.
5 - The Phase Control
can be used to adjust the output of the subwoofer
depending on location. This adjustment can be made by ear to determine
which setting is preferred.
After all the above setting are complete,
THE WATERPROOF COVER SHOULD BE REATTACHED AND LEFT IN PLACE.
These settings should not require changing under normal
use and should be considered “set and leave” controls.
The components in
Stealth Series Subwoofers
are designed for maximum
performance as complete units. Substitution of any other amplifier or
subwoofer is
NOT recommended and WILL VOID The WARRANTY!
SPECIFICATIONS
Max Output Power
AS-10:
500 Watts @ < 0.2% THD
AS-6:
250 Watts @ < 0.2% THD
Frequency Response
20 Hz – 250 Hz
Battery Voltage Range
10.5 VDC – 16 VDC
Variable Low Pass Crossover
50 Hz – 200H z
Variable Bass Boost
0-12 dB @ 45 Hz
Fuse size
1 x 30 A
Size
AS-10
14.75”w (base) x 12.75”h x 11.5”d
AS-6
8.75”w x 8.5”h x 9.25”d
Weight
AS-10
22.4 Lbs
AS-6
16.6 Lbs
ADJUSTMENTS / SPECIFICATIONS
6
Wet Sounds STEALTH ST-AS SERIES SUBWOOFERS Installation / Owner’s Manual
