Before connecting the remote level control,
find a location that is easily accessible for
adjustment. The attached cable will need to be
run to the 3.5mm jack on the harness for the
ST series subwoofer. To avoid the possibility of
induced noise from the vehicle’s electrical system, keep the cable away from
the vehicle’s electrical wiring.
3
INSTALLATION / REMOTE LEVEL CONTROL
Route the Blue Remote Turn On Wire (4)
to a location where it can connect
to the Remote Turn On Output from the source unit. If using the latest Wet
Sounds Stealth Sound Bar, this will be a blue wire. On a traditional head
unit, this wire is often labeled “power antenna remote”. It should be a
wire that su12V when the source unit is powered on and returns
to 0V when the source unit is powered off. If using this turn on method, be
sure that the AUTO TURN ON switch on amplifier built in to the ST series
subwoofer is in the “REM” position.
If the source unit does NOT have a Remote Turn On Output
(like earlier
model Wet Sounds Stealth Sound Bars) make sure the AUTO TURN ON switch
on the amplifier built in to the ST series subwoofer is set in the “AUDIO”
position. See further instructions below for more information on the AUTO
TURN ON switch. Apply tape to insulate the end of this wire if not being used.
Route the 3.5mm plug labeled “Signal Input” (3)
to a location where it can
connect to an audio output from the source unit. On Wet Sounds Sound Bars
this is a 3.5mm jack labeled “AUX OUT”. If using a traditional head unit with
RCA style preamp output, a 3.5mm-RCA adapter will likely be needed.
Route the 3.5mm jack labeled “Remote Level Control” (5)
to a location
where it can connect to the supplied Remote Level Control. This control is
intended to allow easy adjustment of the overall output of the ST series
subwoofer, so mount the control in a location that is accessible.
REMOTE LEVEL CONTROL
Wet Sounds STEALTH ST-AS SERIES SUBWOOFERS Installation / Owner’s Manual
