4
Screw is tightened with a 5mm Allen
wrench after the swivel is adjusted.
Fork must be inserted to
attach the pod to the
bottom of the clamp.
Top Clamp
Bottom Clamp
Swivel Flange
To mount the pod to a
flat deck, remove the
2 Phillips head screws
holding the swivel flange
to the bottom clamp,
then insert screws
through the swivel
flange into the flat area.
Speaker/RGB wires may be inserted from the top of the Pod
through the center of the Swivel Flange & Bottom clamp, then
through a hole in the mounting surface or pipe.
To run the wires without drilling a hole in the surface or pipe, there
is a pre-scored area on the side of the Swivel Flange & the bottom
clamp to remove, allowing the wires to pass through.
Top & bottom clamp will
not be used when flat
deck mounting.
Wet Sounds RECON 6 POD Enclosed Speaker System. Operations / Installation Manual
