TM
4
Remove connector from packaging and disassemble.
See figure 1.
Strip the ends of the speaker wires.
Place Blue Threaded Collar (part A) onto speaker
wire. See figure 1.
Slide the clamping piece (part B) onto the speaker
wire. See figure 1.
Attach the stripped ends of the speaker wires into the
screw down terminals on part C. The terminals are
labeled behind the screw heads. You will use 1+
and 1-. (see wiring diagram) 2+ and 2- will not be
used. (Also, please note there are small metal inserts
that may be placed into the terminals for smaller
gauge wires)
Once wires are attached slide Part D over Part C.
There are tabs that must be aligned. You will need to
rotate the parts. See figure 2.
Slide Part B into Parts C and D. There are also tabs
that must be aligned. You will need to rotate the
parts. See figure 2.
Thread Part A into Part D. Thread all the way down
so the connector is tight.
The connector inserts into the speaker by aligning
the tabs and a push and turn motion. Once inserted,
screw down the blue collar on Part D to keep the
connector tight.
