-6-
REPLACING THE SEAL BAR TAPE:
1. Press the
ON/OFF Button
on the
Control Panel
to turn the
Vacuum Sealer
“OFF”.
2. Disconnect the
Vacuum Sealer
from the
power supply.
3. Make sure the
Vacuum Sealer
is
completely cool.
4. Pick at either end of the
Seal Bar
Tape
covering the
Seal Bar Heating
Element
until it lifts slightly (Figure 6).
Grasp the loose end and slowly pull
the
Seal Bar Tape
back over itself until fully
removed.
5. Remove the backing from a new strip of
Seal Bar Tape
. Be careful not to allow the
Seal Bar Tape
to contact anything including itself while the adhesive side is exposed.
6. Hold one end of the
Seal Bar Tape
in each hand. Stick the left end of the
Seal Bar
Tape
to the flat area on the
Base
just left of the
Seal Bar Heating Element
. Apply the
Seal Bar Tape
from left to right over the
Seal Bar Heating Element
. Make sure there
are no wrinkles or folds in the
Seal Bar Tape
once applied. The
Seal Bar Tape
should
fully cover the
Seal Bar Heating Element
.
Figure 6
Seal Bar Tape
Seal Bar Heating
Element
Summary of Contents for SPORTSMAN'S ADVANTAGE 65-0501-RT
Page 19: ...NOTES...
