Weston SPORTSMAN'S ADVANTAGE 65-0501-RT, Service Instructions Manual

Page: 5 / 20

-5-
REPLACING THE LID ASSEMBLY:
1. Press the
ON/OFF Button
on the
Control Panel
to turn the
Vacuum Sealer
“OFF”.
2. Disconnect the Vacuum Sealer from the power supply.
3. Make sure the
Vacuum Sealer
is completely cool.
4. Press both of the Lid Release Buttons on each side of the Vacuum Sealer to
release the lid lock, then lift the Vacuum Lid to open.
5. Using a Phillips-head screwdriver, remove the 4 Lid Screws in the Plastic Lid
Base (Figure 4).
NOTE:
Short, narrow diameter or angled screwdrivers work best for removing
the screws.
6. Remove the
Plastic Lid Base
, 2
Release Buttons and the 2 Release
Springs
from the
Stainless Steel Lid
.
7. To install the new
Lid Assembly
,
turn the Plastic Lid Base upside down
with the
Vacuum Chamber Lid Seal
positioned towards the front of the
Vacuum Sealer
and the
Chamber Lid
Seal facing you.
8. Place the 2 Release Buttons into
the slots (Figure 5). Insert the 2
Release
Springs into the backs of the Release
Buttons
.
9. With the
Vacuum Chamber Lid
Seal positioned towards the front of the
Vacuum Sealer
and the
Chamber Lid
Seal facing you, carefully position the
Plastic Lid Base Assembly
back onto
the Stainless Steel Lid so that the 4
screw holes in the
Plastic Lid Base
line up with the 4 screw posts on the
Stainless Steel Lid.
10. Use one hand to hold the
Plastic Lid
Base and the other to insert and turn the
4 Lid Screws. HINT:
It may work better
to tilt the Vacuum Sealer on its side when
installing the
Lid Screws
.
11.When all 4
Lid Screws
are installed,
the Plastic Lid Base should be flush
to the
Stainless Steel Lid
. If it is not,
then the Lid Screws may be improperly
installed (i.e. crooked or not tight enough).
Release Button
Figure 5
Release Spring
Plastic Lid Base
Stainless Steel Lid
Chamber Lid Seal
Screw
Posts
Lid Screws
Figure 4