Page 8
Page 9
SET UP & USE
This function provides an extra amount
of steam to remove stubborn wrinkles.
1. Check the water level. Add water if
needed.
2. Turn the temperature control to the
position “MAX.”
3. The temperature operating indicator
light turns off when the required
temperature is reached.
4. The iron is ready for use.
5. Press the Burst of Steam button
once,
.
6. Steam will penetrate into the
garment removing the wrinkles.
7. Wait a few seconds before pressing
the Steam Control Knob again when
there are stubborn wrinkles.
BURST OF STEAM (ALL
MODELS)
FUNCTIONS
SPRAYING (ALL MODELS)
This function can be used with stream
or dry ironing and does not affect the
ironing temperature
1. Check the water level. Add water if
needed.
2. Aim the nozzle towards the
garment.
3. Press the Spray Button,
. Repeat
if spray does not work immediately.
STEAM IRONING (ALL
MODELS)
This function can be used only at higher
ironing temperatures.
1. Check the water level. Add water if
needed.
2. Stand the iron upright and be sure
the temperature dial is set to MIN.
3. Plug the power cord into electrical
outlet.
4. Turn the Temperature Control to the
“••,” “•••” or MAX setting. Consider
the fabric type to be ironed.
For moderate steam
For maximum steam
or MAX
max
max
5. The temperature operating indicator
light turns off when the required
temperature is reached. The iron is
ready for use. The light will go ON
and OFF while ironing.
6. Turn the Steam Knob to the
required position, steam starts
coming out from the holes in the
sole plate.
NOTE:
· With conventional steam ironing,
water may leak from the sole plate
if too low a temperature as been
selected. If this happens, turn the
Temperature Control to the advised
position. Steam will recommence as
soon as the appropriate temperature
has been reached.
To get better result when using vertical
steam, hang the garment on a clothes
hanger. Curtains and rapes may also be
steamed once they’re hung. Hold the
iron away from your body, close to but
not touching the fabric. Pull the fabric
1. Ensure that the Steam Control Knob
is in position “0.”
2. Select the setting on the
Temperature Control. Consider the
fabric type to be ironed.
3. When the temperature operating
indicator light turns off, the required
temperature is reached. The iron is
ready for use.
When the temperature of the iron
drops too low, the water chamber valve
automatically closes. This prevents
hot water from spilling out through the
vents of the soleplate.
Your iron contains an anti-scale
cartridge to reduce scale deposits.
This considerably prolongs the
operational life of your iron.
The anti-scale cartridge is an integral
part of the water tank and does not to
be replace.
VERTICAL STEAMING (ALL
MODELS)
DRY IRONING (ALL
MODELS)
ANTI-DRIP SYSTEM
(ONLY APPLIES TO
WSI300 AND WSI400)
ANTI-CALC SYSTEM
(EXCLUDES MODELS
WSI100 AND WSI200)
SET UP & USE
Diagram for instructional purposes only.
Diagram for instructional purposes only.
max
Diagram for instructional purposes only.
tight with your free hand and pump the
Vertical Steam Button (Steam Button)
at 2-5 seconds intervals as you pass the
iron over the wrinkled fabric.
