3
EN
•
Never operate this unit if it has a damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged, or dropped in water.
•
Keep cords away from heated surfaces. Do not wrap the cord around the exterior
of the appliance or let the cord hang over a table or counter edge.
•
Do not use outdoors.
•
Do not alter the safety plug or use an extension cord with this device.
•
Do not operate with a voltage converter.
•
Do not touch hot surfaces.
•
Do not use accessory attachments not recommended by the manufacturer as
this may case injuries.
FCC INFORMATION
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that
may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment. Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This unit generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit dierent from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
SAVE THESE INSTRUCTIONS
