Westinghouse WDV556HQWA, Manual

Page: 10 / 16

10 www.electrolux.com
TROUBLESHOOTING & ACCESSORIES 5.
Check the points listed here before you call for
help, and make sure that you have followed
the Important safety Instructions on pages 3
and 4.
To operate efficiently the clothes dryer
must have an unrestricted air supply
and exhoust ventilation.
Should you require further instructions
in the use and care of your clothes
dryer please contact the CUSTOMER
CENTER on the phone number listed
below:
If you have a warranty or spare parts
enquiry you should call the number
listed on page 11.
You can buy venting kits (as mentioned
on page 5) from your local appliance
shop or Electrolux Home Products
Pty.Ltd. Parts Distributor.
THE COST OF THIS TYPE OF CALL
WILL BE CHARGED TO THE
CUSTOMER
Service calls resulting from installation
where ventilation is restricted are not
covered by warranty.
Problem
The dryer
will not
start:
Possible causes
Plug is not firmly in socket, or power not
turned on.
The selected drying time was insufficient.
Select a longer time setting.
Longer time may be needed when the
room temperature is 10 ºC or less.
Check that the lint filter is not blocked.
Check to see that you have read all the
instructions carefully.
Contact the Service Center if you are still
having problems. Write down the model
and serial numbers and the date of
purchase before you ring. The Service
Center will need this information.
You have blown a fuse. Check the power
point with another appliance.
You have not closed the dryer door or
pushed in the door safety switch button.
Important
5.1 Troubleshooting
5.2 Accessories
Possible Failures
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please check possible cause of malfunction
and solution listed below.
Once the problem has been eliminated,
press the Start/Pause button to restart the
program. If after all checks, the problem persists,
contact your local Service Centre.
WARNING! Deactivate the appliance
before you do the checks.
Alarm Code Indicator:
The appliance door is open or not
closed correctly. Please check the door!
The main supply is unstable. Wait until
the main supply is stable.
Communication error between electronic
boards of the appliance. Switch off
and switch on again.
Dry LED blinks 4 times
End LED off
Dry LED blinks 11 times
End LED off
Dry LED blinks 9 times
and then off
End LED blinks 1 time
Your
clothes are
still wet/not
fully dried
Load is too small for autosensing program
or load consists of some multilayered
items. Use Time Dry program to complete
drying, refer Hints in section 4.