MAINTENANCE
ACCESSORIES
SPECIFICATIONS
6
Warning !
Maintenance and repair work should only be done by a qualified service technician. When servicing a tool, it’s
recommended to use only spare parts provided by the manufacturer of the tool.
Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and
components which could cause serious hazard.
CAUTION !
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Regularly clean the tool’s air vents with compressed dry air. do not attempt to clean by inserting pointed objects
through openings.
CAUTION!
Certain cleaning agents and solvents may damage plastic parts. Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.
To ensure safe use and maximize service life of your tool, following instructions should be observed:
1. Regularly inspect the grinding wheel----ensure that the grinding wheel is free of cracks and surface defects.
Replace the grinding wheel when it has worn out.
2. Periodically check the mounting screws—regularly inspect all mounting screws and ensure that they are
properly tightened.
3. Regularly clean the air vents of the tool.
4. Check and replace carbon brushes when necessary. When it’s necessary, peel off the labels on both sides of
the tool. Remove the carbon brush caps with screwdriver. Pull out the carbon brushes for inspection. If the
brushes are worn out, they should be replaced with a new pair of brushes. Note that the brushes must be
replaced in pair. Make sure the brush can be slided freely inside the brush holder. Put back the brush caps and
tighten them with screws. Be careful not to overtighten the screws.
spanner-------------------------------------1pc
side handle---------------------------------1pc
carbon brush ------------------------------1pair
instruction manual------------------------1pc
Model: PT20360
Voltage: 120V
～
60Hz
Rated Power: 950w/ 7.5A
Wheel Size: 115mm
No Load Speed: 11,000 RPM
Summary of Contents for PT20360
Page 9: ...9 EXPLODED VIEW...
Page 10: ......
