Installation Method
Fig 8 Connect the water pipe to the water inlet and water outlet connections, please remember
to fix the rubber seal ring.
• If the appliance is equipped with a cable, it is no need to uninstall the case during the
installation.
• Water Connections
1, All water pipe must comply with national and applicable state and local water pipe codes.
2, A pressure relief valve must be installed if the cold water supply pressure exceeds 1Mpa
3, The unit should be connected directly to the main water supply. Flush pipe with water to
remove any debris or loose particles
4, It is required to use G1/2” water connections to fit the appliance.
5, Please remember to install rubber seal rings at the connections. When all water connections
are completed, check for leaks and take corrective action before proceeding.
• Electrical connection
1, All electrical work must comply with national and applicable state and local electrical codes
2, All unit must be connected to a properly grounded dedicated branch circuit of proper voltage
rating.
3, It should be connected to a single circuit, use a supply cable protected by a double pole
breaker
4, While fed the cable to terminal blocks, please make sure the metal wire ends and the terminal
blocks to touch completely. Then tighten the screws up to make sure the full current can go
through.
5, Before beginning any work on the electric installation, be sure that main breaker panel switch
is OFF to avoid any danger of electric shock, all mounting and plumbing must be completed
before proceeding with electrical hook-up.
Summary of Contents for HT382E55
Page 12: ......
