24
GS-26-JH08-WH21
FIGURE 1.
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into mounting bar (B). Secure the mounting screws (A) with hex
nuts (C).
3. Place mounting bar flush against ceiling at desired mounting location. Using outside
mounting bar holes as a guide, mark where pilot holes are to be drilled.
4. Inset two plastic anchors (D) into the pilot holes (for drywall ceiling).
5. Align outside mounting bar holes with plastic anchors (D) (If applicable). Secure mounting
bar (B) into place using wood screws (E).
6. If need adjusting length of fixture, loosen set screw (J) at the wire nut (F) and carefully insert/
pull the cord (G) into/from the canopy (H). Then, secure the set screw (J) at the desired wire
location.
7. Make an electrical connection by loosening the terminal screws on the terminal block (M)
and inserting the live [L] to live terminal and neutral [N] to neutral terminal.
8. Tighten terminal screws. Make sure there are no stray wires.
9. Raise canopy (H) to ceiling, allowing mounting screw (A) to protrude through openings in
canopy (H) and secure into place with cap nuts (T).
10. Attach the shade (D) to holder (I), and rotate the shade (D) clockwise until secure.
11. Turn power back on at circuit box.
MOUNTING AND WIRING INSTRUCTIONS
M
J
A
C
E
T
D
B
H
F
D
G
I
Summary of Contents for 61195
Page 45: ...GS 26 JH08 WH21 45 ...
Page 46: ...46 GS 26 JH08 WH21 ...
Page 47: ...GS 26 JH08 WH21 47 ...
