2
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-5852775-RevA
ECO #: W18-0157
DATE: 04/16/19
PROCEDURE
1. Remove contents from box, verify if all parts listed are present and free from damage.
Carefully read and understand all instructions before attempting installation.
Failure to identify damage before installation could lead to a rejection of any claim.
2. Start installation on either side of the vehicle. Locate mounting locations with factory threaded holes with caps covering
them. Remove factory caps from threaded holes, they will not be used again. Locate (1) Front Mounting Bracket and
loosely install it to the front mounting location on the rocker panel using (2) Long M8 hex head cap screw, (2) M8 split
lock washer, and (2) M8 flat washer. Locate the Center and Rear Mounting Brackets (Item 3) and loosely secure in the cor-
rect mounting locations on the rocker panel. Loosely install using the provided M8 hardware.
See Figure. 1 and 2.
3. Repeat Step 2 for the other vehicle side.
Fig 1
Fig 2
11
10
9
9
10
11
Installation similar for all
Center and Rear Locations
4. For step bar installation, use the supplied M10 Hardware to loosely secure the step bar to the preinstalled brackets. See
Figures 3 & 4
.
Note: All brackets install similarly to step bar.
5. Align and adjust the step bars and brackets as needed, then fully tighten all hardware: M8 to 18 ft-lbs, M10 to 38 ft-lbs.
Fig 3
Fig 4
