3
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank You for choosing Westin products
For Additional installation assistance please call
Customer service (800) 793-7846
www.westinautomotive.com
P.N.: 75-B80003 Rev. B
DATE: 06/26/15
Alternative Rear Mount Instructions
1. Use this method if you have space constraints in the rear mounting of the unit.
See Figure 3
2. Pull drawer out of unit, once drawer hits the positive stop, reach into the box and remove the stop by removing the bolts
with your 1/2” socket. Completely remove the drawer and set it aside.
3. Center the rear mounting bracket on the Bed Safe housing and mark two holes in the floor and two holes in the Bed Safe.
4. Drill 1/2” holes in all four locations.
Note:
After holes are drilled be sure to sweep out all shavings from inside the box,
failure to do so results in the drawer operating improperly and roughly.
5. Place box back into position and install the plus nuts according to the “Plus Nut Installation Procedure” in step 4 of the
previous section. Put drawer back into position and reattach the positive drawer stop inside the box.
6. Secure using 5/16” x 1 1/4” hex head screws, flat washer and lock washer as seen in
Figure 3
.
Stacking Bed Safe Units Mount Instructions
1. Once lower Bed Safe is properly installed, place the next Bed Safe on top and use the angled mounting plate to attach the
two units in the rear section. Use previously stated “Plus Nut Installation Procedure”.
See Figure 4.
2. Remove the top drawer stop and remove and set aside the drawer. Remove the two conveyer rollers and mark the outer
slots. Remove the top box and drill 1/2” holes then follow the “Plus Nut Installation Procedure”.
See Figure 5
3. At this point remove all shavings from the drilling process from both boxes, failure to do so results in the drawer operating
improperly and roughly.
4. Secure all six locations with 5/16” x 1 1/4” hex head screws, lock washers, and flat washers.
5. Replace conveyer rollers, put drawer back into position and reattach the positive drawer stop inside the box. Failure to
replace stop could result in the drawer falling out of the case and possibly personal injury.
Fig. 3
REAR
REAR
Plus Nuts In-
Fig. 4
FRONT
Fig. 5
Front Mounting Location
