Westfield W130-31, Operation And Assembly Manual

Page: 23 / 48

W
ESTFIELD
- G
RAIN
A
UGERS
3. A
SSEMBLY
W130 - 31’ & 36’ PTO-SD & EMD
30749 R0 23
To install:
1. Place driveshaft shield
against gearbox and over
chain coupler guard, then
secure with a guard strap and
2 self-tapping screws (Figure
3.7).
2. To install remainder of the
driveshaft shielding, work
from the bottom up. Shields
should overlap at bearing support brackets (Figure 3.10).
Note: When installing driveshaft shielding, refer to step 1 in Table 3.1.
3. Fasten with shield strap and self-tapping screws. Do not tighten until all
shielding is in place.
3.9. DISCHARGE SPOUT
1. Attach discharge spout with two
7/16" x 1-1/4" bolts and locknuts
(Figure 3.11).
Figure 3.10
Table 3.1 Driveshaft Shielding Sequence
STEP
13” x 31’ SD 13”x 31’ EMD
QTY LENGTH QTY LENGTH
1 1 42" (1.07 m) 1 42" (1.07 m)
2 6 48" (1.22 m) 4 48" (1.22 m)
3 - 42" (1.07 m) 1 42" (1.07 m)
STEP
13” x 36’ SD 13” x 36’ EMD
QTY LENGTH QTY LENGTH
1 1 42" (1.07 m) 1 42" (1.07 m)
2 6 48" (1.22 m) 4 48" (1.22 m)
3 1 60" (1.52 m) 1 60" (1.52 m)
Figure 3.11
7/16” X 1-1/4” BOLT
AND LOCKNUT