3. A
SSEMBLY
W
ESTFIELD
- G
RAIN
A
UGERS
W130 - 31’ & 36’ PTO-SD & EMD
20
30749 R0
Figure 3.7
3.7. EMD DRIVE
and 3.9.
Upper sections of the driveshaft are factory installed. To install the lower section
follow the steps below.
1. Check Table below for correct sequence for your auger.
2. Clean dirt and paint from driveshaft ends and inside couplers.
3. Remove chain from chain coupler on gearbox, then attach chain coupler
sprocket to driveshaft with a 1/4" x 1-1/2" square key. Tighten set screw.
4. Place gearbox assembly on auger tube, then reinstall chain coupler leaving
minimum of 1/16" between coupler sprockets.
5. Secure gearbox assembly to auger tube with two half bands and four
7/16" x 1-1/4" bolts and locknuts. Tighten securely.
6. Attach the chain coupler guard to gearbox base with two 3/8" x 3/4" bolts and
washer locknuts.
Important:
Ensure that gearbox is half full with EP90 lube oil before operating auger. Do not
overfill. Failure to heed will void warranty.
It is easier to fill oil into the gearbox
when it is in the horizontal position.
AUGER MODEL
LOWER DRIVESHAFT
LENGTH
DIAMETER
13” x 31'
19"
1-1/4"
13” x 36'
42"
1-1/4"
Summary of Contents for W130-31
