18
Operation
Hints for Operation
When using the angle grinder for cutting, avoit tilting the angle grinder out
of the cutting line. It is advisable to use diamond discs when cutting hard
stone.
For the best results while rough grinding hold the machine against the
surface in an angle between 30° and 40° in smooth, even movements.
The maximum permitted speed of the disc must be equal to or higher than
the maximum no load speed of the machine. The maximum permitted
speed of the cutting disc is printed on the disc.
Use only cutting or grinding discs with a maximum permitted rotation
speed of 11000 rounds per minute.
Never cut materials containing asbestos with this angle grider.
Using the safety hood for Cutting Disc
When using cutting disc with the angle grinder, always use the safety
hood for cutting discs.
Observe the rotating direction when attaching the cutting disc. You will find
the rotating direction arrow on the cutting disc.
Wear protective clothing such as goggles, gloves, sturdy shoes and ear
protection.
Never stress cutting discs laterally. There is risk of breaking or splintering.
Please note that after work the cutting disc
and the work piece become very hot. There is
risk of burns! Make sure to use always the
right cutting disc for the job.
1. Attach the safety hood for cutting disc on the
angle grinder as shown in the picture.
2. Secure the work piece and place suitable
wedges under the work piece. When operating
the angle grinder, do not press the cutting disc
too much on the work piece. The self weight of
the angle grinder is enough to perform the cut.
Avoid overheating the cutting disc; allow the
disc to cool down sufficiently.