17
Operation
For discs up to 3 mm strong install the outer flange with the flat side to the
disc (Fig. 1). For discs stronger than 3 mm install the outer flange with the
stepped side to the disc (Fig. 2).
Make sure the cutting disc rotates in the direction of rotation (10) printed
on the machine housing.
After installing a disc perform a brief test run. Discs which cause vibrations
and run unround must be replaced immediately.Keep the disc away from
moisture and oil and protect it from either hitting or severely bumping
against any object.
Adjusting the Safety Hood
The safety hood should be aligned is such a way that it protects you from
sparks and flying debries.
1. Remove the outer and inner flange and lightly unscrew the four cross slot
screws.
2. Turn the safety hood to the desired position and fix the safety hood in this
position by tightening the four screws. Before starting the maching check if
the safety hood is fixed correctly. It sould not be able to move the safety
hood.
ON/OFF Switch
1. To turn the angle grinder on, lightly tilt the ON/OFF switch (3) and push it
up to the end in order to lock the switch in this position.
2. To switch off the angle grinder, press the ON/OFF switch on the outer end.
The swtich becomes released and the angle grinder turns off.
Fig. 1 Fig. 2