Westfalia 83 72 29, Instruction Manual

Page: 7 / 18

Safety Notes
3

Make sure the voltage corresponds to the type label on the unit.

Persons with limited physical, sensorial or mental abilities are not allowed to
use the unit, unless they are supervised and briefed for their safety by a
qualified person.

Disconnect the machine from the power supply before inserting the tool,
cleaning or servicing it.

Do not use grinding discs with a diameter more than 25.1 mm!

Do not force the tool.

Use clamps or a vice to hold the workpiece.

The use of any accessory or attachment other than those recommended in
this instruction manual may present a risk of personal injury.

Do not touch the rotating chuck and the tool bit in it, as this may cause cuts or
burns.

Always hold the drill and milling machine firmly in your
hand. The tool bit can suddenly get stuck, which may
cause injuries.

During operation always wear safety goggles and if necessary ear protectors
and a face mask, depending on the used material.

Keep the drill and milling machine out of reach of children. The machine is not
a toy.

Do not press the axle locking pin (5) while the machine is running!

Operate the unit only indoors or in dry areas.

Do not stress the cord. Do not bend the cord and keep it away from hot and
sharp surfaces. Do not wind the cord around the unit.

Keep the work area clean. Dress appropriately.

Should the unit become damaged do not use it and have it repaired by a
professional or contact our customer support department. Do not disassemble
the unit or try repairing it yourself.
Please note the included General Safety Notes and the
following safety notes to avoid malfunctions, damages or physical
injuries: