13
Operation
Intended Use
This angle grinder is intended for cutting and grinding metal and stone with the
suitable discs.
Setup
Please make sure the power power mains voltage corresponds to the
operating voltage stated on the type label. Devices designed for 230V~ can be
run from 220V~ mains and vice versa.
Attaching the Accessory Handle
Do not operate the angle grinder without the accessory handle (2). There are
three threaded holes in the transmission housing, one in each side and one in
the middle, to which the handle can be attached.
Changing the Disc
Please Note! Always pull the power plug before changing a disc to avoid
accidental starting.
Lossen the retaining nut (5) with the included face spanner. Keep the locking
button (1) pressed to lock the drive shaft. After that, replace the disc.
1 Locking Button
2 Safety Hood
3 Inner Flange
4 Cutting Disc
5 Outer Flange
Please Notice! Press the locking button only after the motor has come to a
complete stop.
For discs up to 3mm strong install the outer flange with the flat side to the disc
(Fig. 7), for discs stronder than 3mm install the outer flange with the stepped
side to the disc (Fig. 8).
Fig. 6