![background image](http://html1.mh-extra.com/html/westfalia/60-58-40/60-58-40_instruction-manual_962954024.webp)
19
Cleaning
Camera Installation
You may mount the camera using the
license plate’s top or bottom mounting
bolts or screws. Make sure that its
field of view is not obstructed. Use the
supplied wedge shaped shims to
adjust the angle of the camera.
At some type of cars it is not possible
to mount the camera to the license
plate. You may have to find a different
spot at the back of your car to mount the camera with the
supplied bolts and screws.
1. Loosen the license plate bolts/screws, and then remove
the rear license plate.
2. Insert each license plate bolt into a supplied wedge, then
through the bolt holes of the camera, then through the re-
maining wedges and the license plate (picture).
The power cable attached to the camera should be face up (in
case it is easier to install the camera’s power cable facing down,
the monitor inside your car should be installed upside down as
well).
3. Align with holes on vehicle and temporarily tighten the
license plate bolts/screws. The wedges will angle the
camera down.