10
Using
Before first Use
Remove the unit and the accessory out of the packaging. Keep packaging
materials out of reach of children. There is risk of suffocation!
Assembling
1. Open the container clips (5) and remove the accessory
parts from the container. Insert the motor filter (13) into
the opening of the motor. Insert the adaptor of the dust
bag (7) into the suction insert on the motor housing.
2. Close the dust bag with the dust bag clip (8).
3. Place the motor housing on the container and connect
both parts with the container clips.
4. Insert the adaptor of the suction hose (10) into the hose
insert (4). Connect the other end of the suction hose
with the tool you want to operate by using the suitable
tool adaptor (12).
5. Connect the power plug of the tool
with the power tool socket (1) at the
rear side of the chip vac. (the power
consumption of the power tool must
not exceed 2400 W).
Using
Make sure the power tool is switched off
before connecting the power plug of the
chip vac with mains supply.
The chips vac offers two operating
modes.
Switch to stage
I
:
The unit is in continuous mode, that means, the motor will
operate permanently.
Switch to stage
R
:
When the power tool is switched on, there is a delay of
approx. 3.5 seconds before the chip vac will also switch
on. When the power tool is switched off, there is a delay
of 10 – 15 seconds before the chip vac will switch off.
13