9
Operating
ON/OFF Switch
The ON/OFF switch (11) is located on the handle below the LC Display (10).
1. Insert the power plug into a grounded wall socket.
2. Now push the switch to the left. The display shows the value
00
. Press the
speed controller
+Plus
(13) and the polisher starts with the lowest speed
of 1000 rpm.
3. To switch off the machine push the switch to the right.
Speed Control
After switching on and pressing the
+Plus
(13) button, the polisher will always
start at the lowest rotation speed. You will see the value 10 on the display. The
digits range from 10 to 30 and represent the rotation speed from 1000 to max.
3000 revolutions per minute.
1. Use the speed controller
+Plus
(13) and
–Minus
(12) to increase or
decrease the rotation speed to the desired level. Each time you press the
button
+Plus
the rotation speed increases up to 100 revolutions per
minute. By pressing the button
–Minus
the values will decrease up to 100
revolutions per minute.
2. Always start with the lowest rotation speed in order to avoid splashes
when applying polish on the surface.
Please note: use the ON/OFF switch to turn the machine off after use.
Never just unplug the power cord. Otherwise the machine will start up
again immediately after the power plug has been plugged in again and
rotates uncontrolled.
Before switching on the machine, always ensure that the ON/OFF switch
is in the “OFF” position.
Attaching the Accessories
The polisher is supplied with both a foam pad (6) and a buffing pad (5). Both
pads have a felt mat on the upper surface which adheres to the hook and loop
system.
The foam pad can be used to apply either polish or abrasive. The buffing pad
can then be used to polish the surface.
Always make sure that there are no dirt particles in the foam or buffing pad
before starting your work. Dirt particles can cause scratches on the surface
being polished.
