18
G. TIPS, CARE, AND REPAIR
Ø
Western Shelter Systems provides protective
bags for shipping and storage. Do not drag
these bags on the ground.
Ø
Replacing the components in the proper
bags or aluminum cases ensures all parts
are accounted for and ready for the next
deployment.
Ø
Cleaning and drying of your shelter system
will extend the life of the shelter and eliminate
health issues associated with particulate
buildup. Maintenance is best performed when
the shelter is being taken down. If the shelter
must be packed when wet and/or dusty, It is
VERY important that the shelter is cleaned
and dried as soon as possible.
Ø
Utilize the following steps to ensure that
proper care and maintenance has been
performed.
1. Vinyl Panels (roof, walls, and floor)
q
Clean and fold on a clean surface, such as the
shelter floor. Sweep off loose debris. Remove
debris from hook and loop fasteners using a
rigid brush.
q
Clean with a mild solution such as Simple
Green™, Tilex™, or 10% bleach water solution.
q
Do not saturate the fabric, especially the
hook and loop fastener, which tends to retain
water even after prolonged drying times.
q
Dry thoroughly using towels, leaf blowers or
sunlight.
2 Insulation Panels (roof & walls)
q
Clean and fold on a clean surface, such as the
shelter floor. Sweep off loose debris. Remove
debris from hook and loop fasteners using a
rigid brush.
q
Clean with a mild solution such as Simple
Green™, Tilex™, or 10% bleach water solution.
q
Do not saturate the fabric, especially the
hook and loop fastener, which tends to retain
water even after prolonged drying times.
q
Do not spray cleaner directly on fabric as it
could soak into the air bubbles on the fabric,
leading to mold and mildew. Spray cleaner on
shop towels and wipe to clean.
q
Never pressure wash the insulation panels.
q
Dry thoroughly using towels, leaf blowers or
sunlight.
Ø
Note:
Stains can occur on the white insulation
fabric. These stains, once cleaned, are purely
cosmetic and do not indicate product failure
or health risks.
3. Main Frame, Eave & Base Bars
q
Brush off loose debris. Clean dirt and debris
out of the ends of the bars and legs. Wipe
down with a mild solution such as Simple
Green™, Tilex™ or a 10% bleach water
solution.
q
Dry thoroughly using towels, leaf blowers or
sunlight.
4. Hinge Points & Pull Pins
q
Keep moving parts free of debris and dust.
Disassemble and clean if binding occurs.
q
Do not use liquid lubricant on moving parts,
as this will cause fouling.
