Western Co WRD, User Manual

Page: 5 / 33

WRD
Manuale utente
EN
4
5) Check the entire functioning by scrolling the screens.
2.2. Possible Configuration
The WESTERN WRD SYSTEM can work with different combinations of devices.
n. Configurations Monitoring Diagrams in Appendix
1 WRD + WBM battery A1
2 WRD + WRMxx
(1..8)
PV production A2, A3
3 WRD + WBM + WRMxx
(1..8)
battery, PV production, consumption
A4, A5
4 WRD + Leonardo Off-Grid A6, A7
Depending on the current hardware, the configuration must be set on the WRD. This operation is performed on the
menu:
8.0 WBUS CONFIG. where the addresses of the devices connected to the device must be specified W BUS to
facilitate the operation an auto configuration command is available that detects the connected hardware.
Depending on the configuration set, the WRD displays the information and can execute its algorithms using the
available resources. The screens for each configuration are described below.
2.3. System Setup
In the menu: 7.0 SYSTEM the system settings are executed, the list of parameters changes according to the current
configuration. Detailed explanations are described in the chapter Configurations .
2.4. Date Time Setup
In the menu: 7.1 DATE / TIME you set the system clock and the time zone (Timezone). It is important to correctly set
this last parameter with the Timezone of the place where the system is located, so that the remote clock can be
updated correctly.
2.5. Data Logger Setup
In the menu: 7.2 DATA LOGGER you can enable the data logger by setting the minutes for the sampling parameters:
ϭϬŵŝŶ͘ŝƐƚŚĞĚĞĨĂƵůƚǀĂůƵĞ;ĞŶĂďůĞĚͿ͘/ƚŝƐĂůƐŽƉŽƐƐŝďůĞƚŽƌĞƋƵĞƐƚŝŶĨŽƌŵĂƚŝŽŶƌĞŐĂƌĚŝŶŐƚŚĞʅ^͘
2.6. Network Setup
In the menu: 7.3 NETWORK you make the settings of the various network parameters. The DHCP function is set by
default, which automatically retrieves the necessary values. The connection to the remote server can be enabled or
disabled by the user.