Western Co Leonardo Off-Grid 1kW-1500-24 MG, User Manual

Page: 30 / 40

Leonardo Off-Grid 1kW/1500/24 GE-SL
User Manual
EN
10
LED STATUS warning table
LED STATUS
GREEN LED: normal working status activated ON .
LED STATUS
no.1 flash of RED Led every 10 seconds:
OVER-TEMPERATURE
alarm status.
LED STATUS
No.2 RED LED flashes every 10 seconds: LOW-BATTERY alarm status.
LED STATUS
No.3 RED led flashes every 10 seconds: OVER-LOAD alarm status.
Tab.4 STATUS LED signalling
WARNING: in case of BLOCKED inverter, there is no supply voltage at the output AC-OUT, because
occurred one of the three fault conditions specified in the Tab.4, a RESTART of the device is necessary, by
pressing the RESET button on the base of the device (Pic. 12).
INSTALLATION AND WIRING
a) Install Leonardo Off-Grid 1kW/1500/24 GE in a dry and adequately ventilated place, fixed on a non-combustible
surface and positioned in order to have a space free of obstacles of at least 10 cm around the device so to have
the cooling by forced air convection.
b) Fix the wall mounting bracket (supplied) using the provided plugs and screws; then fasten the inverter through
the hooked plate on the upper part of the device. Finally secure the inverter to the wall using the holes at the
bottom of the unit. As shown in Pic.
11 .
Pic. 11 Wall Mounting
c) Connect in the following order:
1. positive battery cable (See connection in the section
Direct Current Side Protection
);
2. negative battery cable;
3. activate battery cut-off switch - ON position ;
4. connect
PV modules PV1-PV2-PV3-PV4 (
verifying the polarity of each pair of cables that have to be
connected on the input inverter);
HOOCKED PLATE
top
of the inverter
MOUNTING
BRACKET
PLATE
bottom part
of the inverter