21
6642-22541
Cable factory reset
It is possible to set the product to factory default settings by using a standard Ethernet
RJ-45 cable.
1. Power off the product and disconnect all cables.
2. Connect an Ethernet cable between Ethernet ports 1 and 2. The product needs to be
connected directly by an Ethernet cable i.e., not via a hub or switch. Use a straight cable
– not a cross-over cable, when connecting the ports.
3. Power on the product.
4. Wait for the product to start-up. Control that the ON LED is flashing red. The ON
LED flashing indicates that the product is now ready to be reset to factory default.
You now have the choice to go ahead with the factory reset, or to skip factory reset
and boot as normal.
• Go ahead with factory reset:
Acknowledge that you wish to conduct the factory reset by unplugging the Ethernet
cable. The ON LED will stop flashing. This initiates the factory reset process*, and
the product will restart with factory default settings. When the switch has booted
up, the ON LED will show a green light, and is now ready to use.
• Skip the factory reset:
To skip the factory reset process, just wait for approximately 30 seconds (after the
ON LED starts flashing RED) without unplugging the Ethernet cable. The switch will
conduct a normal boot with the existing settings.
*
Note
Do not power off the product while the factory reset process is in progress.
Referring documents
Type
Description
Document number
Management Guide
Westermo OS management guide
6101-3201
Dimensions
Measurements are stated in millimeters.
92 ±1
Min 4mm
Max 7,5mm
34
±1
96 ±1
52 ±1
100
±1