11
6641-22501
100 Mbps, non-PoE ports
Electrical specification
IEEE std 802.3.
Data rate
10 Mbps, 100 Mbps, manual or auto
Duplex
Full or half, manual or auto
Circuit type
TNV-1
Transmission range
Up to 150 m with CAT5e cable or better
Isolation to
±
2250 VDC to all other ports*
Connection
4 pin M12 D-code, auto MDI/MDI-X,
recommended Westermo cables:
3146-1100 M12-M12 – 1 m
3146-1101 M12-M12 – 5 m
3146-1103 RJ45-M12 – 1 m
3146-1104 RJ45-M12 – 5 m
Shielded cable
Required
Conductive chassis
Yes
FRNT reconfiguration time
Typically below 20 ms
100 Mbps, non-PoE ports are:
X4, X8, X11-X12 on Viper-x12A-P8-HV/LV
X11 on Viper-x12A-T3G-P8-HV/LV
*
±
750 VDC after damp heat, according to EN 50155
Gbps ports, non-PoE ports
Electrical specification
IEEE std 802.3
Data rate
10 Mbps, 100 Mbps, 1000 Mbps, manual or auto
Circuit type
TNV-1
Transmission range
Up to 100 m with CAT5e cable or better
Isolation to
±
750 VDC to all other ports
Connection
8 pin M12 X-code
Shielded cable
Required
FRNT reconfiguration time
Typically below 20 ms
Gbps non-PoE ports are:
X4, X8, X12 on Viper-x12A-T3G-P8-HV/LV
PoE ports
Electrical specification
IEEE std 802.3
Circuit type
TNV-1
Transmission range
Up to 100 m with CAT5e cable or better
Isolation to
±
750 VDC to all other ports
Output voltage
54 VDC, ±5%
Output power**
Max 30 W on one port (PoE+)
Max 61.6 W in total on all ports
PoE ports are: X1-X3, X5-X7, X9-X10.
Note!
PoE ports are not isolated to each other.
**
As delivered by Power Sourcing Equipment, i e the Viper-x12A-PoE switch. Power available at Powered Device
is depending on cable resistance.
