Connecting to Network
1. Connecting the Ethernet Ports: Connect one end of an Ethernet cable into an RJ-45 port
SDI-880/SDI-862, while the other end is connected to the attached networking device. All UTP ports
support auto MDI/MDIX function. The Speed LED will turn on for 100M link and turn off for 10Mbps
link, the LNK/ACT LED will turn on for link up and blink for packet transmit and receive. The fiber
ports only support 1 LED for Link and Activity.
2. Connecting the Fiber Ports (SDI-862) : Connect the fiber ports on your SDI-862 to another Fiber
Ethernet device, by following the figure below. Wrong connection will cause the fiber ports not work
properly.
DIP Switch Settings for Alarm Relay Output
Ǽ
This is a Class 1 Laser/LED product.
Don't look into the Laser/LED Beam.
ATTENTION
RX
TX
RX
TX
Cable Wiring(SC to SC)
RX A TX B
TX A RX B
P1 to P8
(Pin1 ~ 8)
P9
Pin No. #
Status
Description
ON
To enable port link down alarm at this port.
ON
To enable power failure alarm.
Off
To disable port link down alarm at this port.
Off
To disable power failure alarm.
