SDI-880/SDI-862 Industrial Ethernet Switch, conforming to IEEE 802.3 and 802.3u standard, supports
8 10/100Base TX (SDI-880) or 6 10/100TX plus two 100FX Fast Ethernet fiber ports in either
multi-mode type (SDI-862-MM-SC2) or single-mode type (SDI-862-SM-SC30).
The SDI-880/SDI-862 adopts rugged metal case design to operate in harsh environments
(SDI-880 -25~70
o
C)/(SDI-862 -10~70
o
C); It also provides IP-31 standard protection. It features one
relay output to alarm users if a port link fails or in the event of a power failure. Alarms can be
enabled/disabled by a 9-pin dip switch. SDI-880/SDI-862 is recommended to be powered by DC
12V/24V/48V with 10~60V range from the 6-pin removable terminal block.
Introduction
Box contents
SDI-880/SDI-862 Switch
Quick Installation Guide
Mounting the Unit
Din-Rail mount: Mount the din-rail clip
screwed on the rear of SDI-880/SDI-862 on the DIN rail.
Grounding SDI-880 / SDI-862 Switch
There is one grounding screw on the bottom side
of SDI-880/SDI-862. Connect the earth ground
screw of switch to the grounding surface to ensure
safety and prevent noise. See, Figure-1
Package contents Check List
Earth Ground
Screw
Earth Ground
Warning: Do not connect to AC line neutral
Figure-1
DC1
DC2
Alarm
A
B
Alarm control
1 2 3 4 5 6
Port
Power
7 8
©
W
estermo
Teleindustri
AB
www.westermo.com
Industrial Ethernet Switch
SDI-880/862
Quick Installation Guide
