Weslo Sport 50, User Manual

Page: 5 / 16

5
3
43
19
45
20
39
20
39
39
20
41
41
41
1
13
36
3. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire (36) to the
Reed Switch Wire (43). Cut and remove the zip tie
holding the Reed Switch Wire to the Frame (1). Next,
connect the Resistance Cable (19) to the Lower Cable
(45) in the following way:
• See inset drawing A. Pull up on the metal bracket (A)
on the Lower Cable (45), and insert the tip of the
Resistance Cable (19) into the wire clip inside of the
metal bracket.
• See inset drawing B.
Firmly
pull the Resistance
Cable (19) and slide it into the metal bracket (A) on
the Lower Cable (45) as shown.
• See inset drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Carefully pull the excess Upper Wire (36) out of the
top of the Upright (13), push the excess Cables (19, 45)
down into the Frame (1), and insert the Upright into the
Frame.
Be careful to avoid pinching the Wires and
Cables. Next, attach the Upright with three M8 x 15mm
Screws (41), three M8 Lock Washers (20), and three
M8 Curved Washers (39).
Be careful to
avoid pinching
the wires and
cables whilst
inserting the
Upright.
4
4. Insert the Handlebar (15) into the Upright (13). Pull the
Upper Wire (36) through the plate on the Handlebar as
shown.
Be careful to avoid pinching the Upper
Wire.
Attach the Handlebar (15) to the Upright (13) with three
M8 x 15mm Screws (41), three M8 Lock Washers (20),
and three M8 Curved Washers (39).
13
15
36
20
20
39
39
20
41
41
41
Be careful to
avoid pinching
the wire.
Zip Tie
A
B
C
45
19
19
A
A
A
45