14
MAINTENANCE
Inspect and tighten all parts of the exercise bike
regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent.
IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace the
batteries (see assembly step 8 on page 9); most
console problems are the result of low batteries.
If the heart rate monitor does not function properly, see
step 3 on page 13.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. Before adjusting the
reed switch, turn the resistance knob to the lowest
setting.
Next, loosen the
screws (not shown)
in the Shields (26,
27), and carefully
remove the Shield
Cover (28).
Locate the Reed
Switch (29), and slide
it upward or down-
ward slightly. Then,
turn the pedals for
a moment and see
whether the console
displays correct feed-
back. Repeat this
step until the console
displays correct feedback.
When the console displays correct feedback, reattach
the Shield Cover (28), and tighten the screws in the
Shields (26, 27).
29
28
26, 27
MAINTENANCE AND TROUBLESHOOTING
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user’s authority to operate this equipment.
Summary of Contents for pursuit ct 3.3 WLEX81915.1
Page 4: ...4 STANDARD SERVICE PLANS ...
